Hello!

Xaudia offer microphone re-ribboning and repair services.

2012/04/30

Cadenza mic XLR modification

Cadenza ribbon microphones are quite common, but there seem to be more microphones than there are connectors for them. The mics were originally supplied with an integrated stand & connector, which was ideal for desk recording, but not very effective for hanging over a drum kit.

This mic was missing its connector, so here is a chop-job to convert to XLR output....


The connector was removed from the mic and the bottom thread cut off and filed flat. Then a piece of brass rod was machined to fit snugly into the base of the mic, and this was bored to accept a standard three pin XLR insert.


The XLR has the added advantages of making a good earth connection, and also gives a way of mounting the mic on a stand as it can be slipped into a standard mic clip. I think elongating the base  makes the look more elegant too.

No comments:

Post a Comment

Post a comment!

Note: only a member of this blog may post a comment.