Hello!

Xaudia offer microphone re-ribboning and repair services.

2011/11/30

MOTM - Lustraphone VR53 (a.k.a. Grundig) ribbon mic.

November's microphone of the month is a British long-format ribbon that was sold under the names "Lustraphone" and 'Grundig".

A Lustraphone-badged ribbon microphone in glorious brushed stainless steel finish
This mic was available in at least three different impedances, and I have come across 30, 200, and high impedance models. Unfortunately the badge often falls off so you don't always know what you are getting! Most of the models I have seen are finished in a bronze hammerite colour, although there is a deluxe low impedance model which has a gorgeous brushed stainless steel finish. Despite the different badges and finishes, the mics are exactly the same on the inside (transformer aside).

Lustraphone ribbon microphones on the bench
One of the ribbon clamps sits on a spring-tensioned screw thread, which allows fine adjustment of the ribbon tension. This makes tuning the ribbon very straight-forward, and allows the owner a little bit of grace if the ribbon becomes a little stretched over time. This feature should probably be mandatory on all ribbonmics!

Grundig badged lustraphone mic, opened up for service
The magnetic field is supplied by a pair of horseshoe magnets (which unfortunately sometimes age with time, losing their strength). Connection to the rest of the world is made by a balanced three-pin paxolin plug, which are hard to come by now. The middle pin is ground, with the audio on the outer two pins.

Rear connector and original plug.
Fortunately, a male XLR connector can be modified to fit by slicing off part of the barrel.

XLR connector modified to fit the mic.
The long ribbon and motor design gives these mics a full bottom end and a pronounced proximity effect. Here are the frequency plots for three of these mics that we have serviced recently:

Lustraphone ribbon mic frequency plots.





(Thanks to Mark Stevens for additional information).


Update 23/1/12. These microphones were also sold under the brand Pamphonic. One appeared recently on ebay:


Update 29/2/12. And here is one with a Mimco badge!

2011/11/28

The shape of things to come....

Here's a sneak preview....

Can you tell what it is yet? :)



2011/11/26

Ed Laurie with a Melodium 42b at Kore Studios

It is very gratifying to know that the mics we service and repair go out and get used to make great recordings.

Of course it is not just the microphone - to make something special you also need good songwriting, a strong performance, and an engineer that knows what to do.
Here we have it all...


This beautiful song by Ed Laurie was recorded by George Apsion at Kore Studios.

George and Kore are good customers of ours, and we recently serviced a pair of Melodium 42bs and a little Cadenza microphone for them. The vocals on the video were recorded using one of the Melodiums, running through an Xaudia impedance matching transformer box. A Neumann U67 was used for the guitar amp, and a pair of AKG 414s as room mics, all into some vintage Neve preamps. I think it sounds stunning!

Ed has a new album out in January, and is currently out on the road.

2011/11/25

The Devil's Own Multi-meter

I used to own a multi-meter, which I inherited from my Grandfather sometime back in the early 1990's. It was a nothing fancy, but had a function for quickly measuring the HFE value, which I found very useful.

Said meter died a few months ago. My newer multimeter lacked this function, so I bought a cheap meter on ebay to fill in the gap.

But it is the devil's multimeter. Whenever I turn it on, the display briefly flashes up the number '666' before reading zero. Here's a video....





Nothing is attached, and the number comes up regardless of the function selected.

Spooky!